NHTSA ID Number: 11719787
Complaint Date: 2026-02-23
Fail Date: 2026-02-23
Manufacturer Name: Ford Motor Company
Vehicle Make: FORD
Vehicle Model: FLEX
Model Year: 2019
Summary
I have recieved the notice from the manufacturer as expected. I have been notified by my local dealership of the recall. I have attempted several times since notification to have it corrected. I have been told on every occasion the parts were not available. Yet, a bit of searching on Ford's own parts website, I can order the part and have it delivered by Feb 26. At every service visit, the dealership has kindly reminded me of the needed recalls. I question, no parts? Is ford just thinking I will get tired and just stop. No parts in stock should mean, NONE in Ford's entire inventory. The part in question is only used on Ford Flex. No other models use this device. The reserved devices cannot be "for new car builds". I believe we are on the edge of a "BAD FAITH" arguement. An issued "Safety Recall" should not mean "Suggested when you have time Recall.
Read More...NHTSA ID Number: 11719786
Complaint Date: 2026-02-23
Fail Date: 2026-02-04
Manufacturer Name: Honda (American Honda Motor Co.)
Vehicle Make: HONDA
Vehicle Model: ACCORD
Model Year: 2003
Summary
My break starts seizing up for no reason just out of the blue and a mechanics can't seem to find them problem, which led to my brake light constantly being on.
Read More...NHTSA ID Number: 11719785
Complaint Date: 2026-02-23
Fail Date: 2025-08-01
Manufacturer Name: Ford Motor Company
Vehicle Make: FORD
Vehicle Model: FOCUS
Model Year: 2016
Summary
My car is showing signs of recalls but it’s stating that it doesn’t have any recalls. There is a recall of the transmission failing because of the clutch and causing the car to just randomly cut off while driving putting risk of a crash to me and my kids There is a recall on the fuel pump being messed up causing the car to cut off randomly while driving because of the vapors and that’s what my car has been doing also putting danger to me and my kids while driving.
Read More...NHTSA ID Number: 11719784
Complaint Date: 2026-02-23
Fail Date: 2026-02-22
Manufacturer Name: Doona
Vehicle Make: DOONA
Vehicle Model: CAR SEAT/ STROLLER
Model Year: 9999
Summary
This writer is a neonatal intensive care registered nurse. This car seat was purchased by a parent of an infant patient for use to take infant home. Seat identified by This writer as counterfeit. Parents counseled on car seats and what to look for.
Read More...NHTSA ID Number: 11719783
Complaint Date: 2026-02-23
Fail Date: 2024-11-27
Manufacturer Name: Honda (American Honda Motor Co.)
Vehicle Make: HONDA
Vehicle Model: CIVIC
Model Year: 2019
Summary
The open recall repair (NHTSA 23V-858) has not been completed. Additionally, there is a separate open recall, NHTSA Recall Number 25E-071 (Manufacturer Recall MMZ), involving 18-inch Honda Genuine Accessory wheels with improperly installed lug seat inserts. Both recalls remain unresolved. Beginning in approximately 2024, the vehicle exhibited intermittent jerking and stalling during acceleration, along with loss of smooth power delivery. No warning lamps were illuminated prior to failure. The vehicle was inspected in July 2025 after Wilkes-Barre Honda declined to provide assistance, and it passed inspection at that time. In October 2025, the engine failed to start, and the vehicle became fully non-operational. The insurance carrier was notified in October 2025 that the vehicle had become inoperable. The vehicle has not been inspected by the manufacturer, law enforcement, or the insurance company. It is currently available for inspection but is not safely drivable. Loss of power while driving presents a risk of collision. Multiple attempts were made to schedule an appointment with Wilkes-Barre Honda regarding the outstanding recall; however, no response was received. The manufacturer was also contacted on several occasions, but no meaningful assistance was provided. Despite repeated requests, the dealership has not conducted a formal inspection or confirmed the cause of the failure. The vehicle has remained inoperable for several months. Under these circumstances, asking me to arrange towing is not reasonable, as delays in addressing recalls have created additional practical barriers to accessing necessary transportation and resources. *Note: I've included a phone number for this complaint but do not have one. Additionally, lack of vehicle access due to unresolved recalls had already created practical barriers in obtaining one.
Read More...NHTSA ID Number: 11719782
Complaint Date: 2026-02-23
Fail Date: 2026-02-21
Manufacturer Name: Honda (American Honda Motor Co.)
Vehicle Make: HONDA
Vehicle Model: ACCORD
Model Year: 2020
Summary
All the lights on the dashboard went off when there was not any previously. With that issue the gas pedal was struggling to go over 20 mph, it was jolting when gas pedal is used.
Read More...NHTSA ID Number: 11719781
Complaint Date: 2026-02-23
Fail Date: 2026-02-13
Manufacturer Name: General Motors, LLC
Vehicle Make: CHEVROLET
Vehicle Model: TRAX
Model Year: 2019
Summary
I was in an accident and the seatbelt pretensioners activated but my airbags did not deploy. When i got my vehicle inspected the shop noticed my airbag system needed to be replaced saying the airbag diagnostic module, right & left front air bag impact sensors needed to be replaced. The impact of my vehicle was very minor and could not have damaged the airbag diagnostic module internally. I do believe this was a preexisting issue and it has just now been noticed when my car had to be thoroughly inspected.
Read More...NHTSA ID Number: 11719780
Complaint Date: 2026-02-23
Fail Date: 2026-02-22
Manufacturer Name: Tesla, Inc.
Vehicle Make: TESLA
Vehicle Model: CYBERTRUCK
Model Year: 2024
Summary
I have the Foundation Cyberbeast, the model which has an OEM light bar on windshield. While driving on 2-22-2026 at approximately 3:30 pm on the 5 freeway near Santa Ana, the appx 4 ft long light bar flew off and ricocheted violently on vehicle, while still attached by the power cord. This damaged many parts of my vehicle, specifically the glass roof, front windshield, and various body components which were shattered or scratched. I cut my hands. Your database says there are 0 open recalls and that is a lie by Tesla, because they sent me a notice months ago saying they are awaiting mechanical attachment methods. So they know they need to change the attachment method from epoxy to mechanical, but are falsely reporting to the government that they already did so.
Read More...NHTSA ID Number: 11719779
Complaint Date: 2026-02-23
Fail Date: 2026-01-22
Manufacturer Name: Honda (American Honda Motor Co.)
Vehicle Make: HONDA
Vehicle Model: PROLOGUE
Model Year: 2024
Summary
2024 Honda Prologue Elite AWD experiences severe drivetrain shudder, banging, and lurching when turning at or near full steering lock at low speeds (e.g., parking lots, U-turns, three-point turns). Severity increases significantly in cold ambient temperatures (below approximately 32°F). The front axle feels as though it is binding and releasing repeatedly, causing the entire vehicle to lurch violently. The condition is present from cold start and does not fully resolve even after the drivetrain warms up after several minutes of driving. The vehicle has been to an authorized Honda dealer three times in approximately one month for this same condition, all under warranty, between approximately 7,660–7,675 miles: Visit 1: Dealer verified failed outer CV joint on left front half shaft. Left front half shaft assembly replaced. Visit 2: Right front half shaft outer CV joint diagnosed as failing. Right front half shaft assembly replaced. Visit 3: Binding and lurching returned in both directions. Both left and right front half shaft assemblies replaced again. Vehicle held approximately two weeks waiting for parts. In total, four front half shaft assemblies have been replaced across three warranty repairs using the same GM part number. The condition returned immediately upon picking up the vehicle after the third repair. While severity is somewhat reduced, the shudder, binding, and lurching during turning persists. This is not a minor clicking noise as some owners have reported — the vehicle lurches and bangs enough to affect steering control. During a test drive, the foreman acknowledged this was clearly a safety issue. The violent lurching during low-speed turns reduces driver control and steering predictability in parking lots, intersections, and residential areas where pedestrians are present. The abrupt jolting could cause a driver to instinctively brake or overcorrect. No warning lamps or DTCs were present during any failure. Symptoms are purely mechanical.
Read More...NHTSA ID Number: 11719778
Complaint Date: 2026-02-23
Fail Date: 2026-02-22
Manufacturer Name: Mercedes-Benz USA, LLC
Vehicle Make: MERCEDES-BENZ
Vehicle Model: C300
Model Year: 2014
Summary
Experiencing a failed Electronic Steering Lock (ESL). Car won’t crank or start even after verifying battery health and key fob. Symptoms point to a failed ESL, left stranded
Read More...
- CEL Doctor: The ANCEL AD310 is one of the best-selling OBD II scanners on the market and is recommended by Scotty Kilmer, a YouTuber and auto mechanic. It can easily determine the cause of the check engine light coming on. After repairing the vehicle's problems, it can quickly read and clear diagnostic trouble codes of emission system, read live data & hard memory data, view freeze frame, I/M monitor readiness and collect vehicle information.
- Sturdy and Compact: Equipped with a 2.5 foot cable made of very thick, flexible insulation. It is important to have a sturdy scanner as it can easily fall to the ground when working in a car. The AD310 OBD2 scanner is a well-constructed mechanic tool with a sleek design. It weighs 12 ounces and measures 8.9 x 6.9 x 1.4 inches. Thanks to its compact design and light weight, transporting the device is not a problem. The buttons are clearly labelled and the screen is large and displays results clearly.
- Accurate Fast and Easy to Use: The AD310 scanner can help you or your mechanic understand if your car is in good condition, provides exceptionally accurate and fast results, reads and clears engine trouble emission codes in seconds after you fixed the problem. This device will let you know immediately and fix the problem right away without any car knowledge. No need for batteries or a charger, get power directly from the OBDII Data Link Connector in your vehicle.
- OBDII Protocols and Car Compatibility: Many cheap scan tools do not really support all OBD2 protocols. AD310 scanner as it can support all OBDII protocols such as KWP2000, J1850 VPW, ISO9141, J1850 PWM and CAN. This device also has extensive vehicle compatibility with 1996 US-based, 2000 EU-based and Asian cars, light trucks, SUVs, as well as newer OBD2 and CAN vehicles both domestic and foreign. Pls confirm with our customer service whether it is compatible with your vehicle before purchasing.
- Home Necessity and Worthy to Own: This is an excellent code reader to travel or home with as it weighs less and it is compact in design. You can easily slide it in your backpack as you head to the garage, or put it on the dashboard, this will be a great fit for you. The AD310 is not only portable, but also accurate and fast in performance. Moreover, it covers various car brands and is suitable for people who just need a code reader to check their car.
- Multi-Functions - Practical Multi-Functions OBD2 code reader features built-in OBD2 DTC lookup library, which help you to determine the cause of the engine light, read code, erase code, view freeze frame, I/M ready, vehicle information, data flow, real-time curve, get vehicle speed information, calculate load value, engine coolant temperature, get engine speed.
- Wide Capability - Supports 9 protocols compatible with most 1996 US-Based, 2000 EU-Based and Asian cars, and newer OBD II & CAN domestic or import vehicles. Supports 6 languages - English,German, Dutch, Spanish, French, Italian.
- 2.8" LCD Display - Designed with a clear display 2.8" Large LCD screen - white backlight and contrast adjustment. No need any battery or charger, OBD reader gets the power directly from your vehicle through the OBDII Data Link Connector.
- Compact Design - Car diagnostic scanner is equipped with a 2.5 feet long cable and made of a very thick flexible insulator.There are 6 buttons on OBD2 Scanner:scroll up/down,enter/exit and buttons that quick query VIN vehicle number& the DTC fault code.
- ABS / Airbag codes NOT Supported - It is able to read and clear check engine information which is part of OBDII system, but it cannot work with non-OBDII systems, including ABS / Airbag / Oil Service Light, etc.
- 【Your Personal CEL Doctor – Read & Clear Engine Codes】The NT301 OBD2 scanner lets you read diagnostic trouble codes (DTCs), check em-issions readiness, turn off your Check Engine Light (CEL) or MIL, reset monitors, and view live data streams. It retrieves your vehicle's VIN instantly. Like all standard OBD2 scanners, it clears codes only after repairs are completed—if the issue persists, the code will return. Designed for DIYers who want to understand what’s really going on under the hood.
- 【Easy Code Reading – Just Plug & Play】Simply plug into the OBD2 port, turn the ignition to “ON” (engine off), and select the correct menu: Select OBDII-> Wait for seconds-> Select Read codes. For accurate results, ensure your vehicle is compatible and the OBD2 port is free from damage or wiring issues. No batteries needed— powered directly by your car.
- 【Live Data Graphing & Accuracy for Most OBD2 Vehicles】View and log live sensor data in graph form—monitor oxygen sensors, fuel trims, coolant temp, RPM, and more. Spot trends and suspicious values in real time. Compatible with most 1996+ gasoline cars, light trucks, and SUVs sold in the U.S., as well as many 2000+ European and Asian models. Also works on 12V diesel vehicles equipped with OBD2.
- 【S-mog Check Helper – Know Your Readiness Status at a Glance】With dedicated I/M readiness hotkeys and a simple Red-Yellow-Green LED indicator, you’ll instantly know if your vehicle is ready for em-issions testing. Built-in speaker provides audio feedback. No guesswork—just confidence before you head to the test center.
- 【A Must-Have Tool for Every Home Mechanic】Compact, rugged, and ready to use right out of the box. The 2.8” color screen is easy to read, even in daylight. No charging or setup required—just plug into the 16-pin DLC and start diagnosing. Recommended by professional mechanics on YouTube and trusted by DIYers worldwide.
Last update on 2026-03-25 / Affiliate links / Images from Amazon Product Advertising API
This product presentation was made with AAWP plugin.