NHTSA ID Number: 11718886
Complaint Date: 2026-02-18
Fail Date: 2025-12-29
Manufacturer Name: Ford Motor Company
Vehicle Make: FORD
Vehicle Model: ESCAPE
Model Year: 2013
Summary
The contact owns a 2013 Ford Escape. The contact stated that while driving at an undisclosed speed, the passenger seated in the front passenger's seat became aware of smoke inside the vehicle. No warning lights were illuminated. The vehicle was taken to an independent mechanic, where the contact was informed that the engine cover had cracked and that there was an oil leak coming from the engine. The independent mechanic cleaned up the oil from underneath the engine and became aware that the wires and additional parts underneath the engine were burned. The contact was informed that there had been a fire underneath the engine. The contact was informed that the vehicle could have caught on fire. The contact referenced an unknown recall, but the VIN was not under recall. The manufacturer was made aware of the failure. The failure mileage was approximately 160,000.
Read More...NHTSA ID Number: 11718885
Complaint Date: 2026-02-18
Fail Date: 2026-02-13
Manufacturer Name: Ford Motor Company
Vehicle Make: FORD
Vehicle Model: F-150
Model Year: 2022
Summary
My 2022 Ford F150 wouldn’t start one morning. There was power and a lot of codes came up on the dash pod. I had it towed to the Ford dealer and they confirmed a no start situation. They replaced the under hood fuse box (warped from heat) and ultimately found a chaffed wiring harness with corroded and broken wires. It’s my opinion that a wiring harness is not a wearable item and this was caused by a friction situation. It’s my opinion that this could potentially be a safety issue if I was driving the vehicle and this happened it would be a total loss of power. The Ford dealer repaired the 2 wires and re-taped the harness.
Read More...NHTSA ID Number: 11718884
Complaint Date: 2026-02-18
Fail Date: 2026-02-13
Manufacturer Name: Ford Motor Company
Vehicle Make: FORD
Vehicle Model: F-150
Model Year: 2021
Summary
The contact owns a 2021 Ford F-150. The contact stated that while stopped, the vehicle hesitated and shuddered while depressing the accelerator pedal. There was no warning light illuminated. The vehicle stopped in the middle of the road and failed to move even while in neutral(N). Due to the failure, the vehicle was towed to the dealer, where it was diagnosed with a defective fuel pump. The contact was informed that the VIN was included in NHTSA Campaign Number: 25V455000 (Fuel System, Gasoline); however, the parts for the recall repair were not yet available. The contact was provided with an estimate for the repair, which the contact approved. The vehicle was repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 60,000.
Read More...NHTSA ID Number: 11718883
Complaint Date: 2026-02-18
Fail Date: 2026-02-17
Manufacturer Name: Toyota Motor Corporation
Vehicle Make: TOYOTA
Vehicle Model: HIGHLANDER
Model Year: 2021
Summary
I am reaching out regarding our 2021 Toyota Highlander which currently has $65 K miles and is just out of warranty. Recently we noticed a wining noise during acceleration. We took the vehicle to the dealer who told us that the transmission will need to be REPLACED. $9500 repair. This is a known issue with Toyota and they will not work with us on this. We are stuck! No customer goodwill! Thank you!
Read More...NHTSA ID Number: 11718882
Complaint Date: 2026-02-18
Fail Date: 2025-12-31
Manufacturer Name: Tesla, Inc.
Vehicle Make: TESLA
Vehicle Model: MODEL Y
Model Year: 2026
Summary
Tesla decided to remove the safety unlock illuminated button from its front trunk (frunk) sometime in mid 2025. This can be a safety issue which was present in earlier models and against the Federal Motor Vehicle Safety Standard (FMVSS) 401, mandating an interior release mechanism for enclosed trunks to prevent entrapment. I contacted Tesla and they told me that my vehicle was made after Tesla decided to remove this safety feature.
Read More...NHTSA ID Number: 11718881
Complaint Date: 2026-02-18
Fail Date: 2026-02-07
Manufacturer Name: Hyundai Motor America
Vehicle Make: HYUNDAI
Vehicle Model: IONIQ 5
Model Year: 2024
Summary
Sudden ICCU failure in 2024 Ioniq 5 electric vehicle . A warning message to check electrical system appeared suddenly on driver dash screen. Tried to drive vehicle off street to a safe place to park. Vehicle shuttered and shook and would only move under 5mph on busy shopping & hospital area of 45 MPH road, placing me and my [XXX] child in danger of being hit by another fast moving car. Vehicle was towed to Bob King Hyundai in Winston Salem. They diagnosed the problem as a failed ICCU. Ongoing and long term problem with Hyundai. Service department has had my car for 11 days so far. They update me frequently. The part has been ordered but there is not ETA. Also, there is no guarantee that the new part will not fail as well. This puts my family at risk every time we drive the car, especially on busy roads and interstates. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Read More...NHTSA ID Number: 11718880
Complaint Date: 2026-02-18
Fail Date: 2025-10-22
Manufacturer Name: Ford Motor Company
Vehicle Make: FORD
Vehicle Model: F-350 SD
Model Year: 2025
Summary
My vehicles turn signal audio indicator is extremely quiet and cannot be heard at speeds above 45MPH creating a safety issue. I have checked the vehicle audio settings in addition to the vehicle owner manual and there is no user setting to adjust audio. I asked the dealer where i purchased my vehicle (Northtown Ford, Menomonie, WI) about the issue and they did not have a solution.
Read More...NHTSA ID Number: 11718879
Complaint Date: 2026-02-18
Fail Date: 2025-12-01
Manufacturer Name: Subaru of America, Inc.
Vehicle Make: SUBARU
Vehicle Model: OUTBACK
Model Year: 2018
Summary
The STARLINK touchscreen display on my 2018 Subaru Outback has experienced progressive delamination — a separation of the screen's protective layer from the display panel — resulting in large, spreading opaque blotches that obscure significant portions of the screen. This is a known manufacturing defect that Subaru of America acknowledged through the issuance of a Technical Service Bulletin and an extended warranty for 2018 model year vehicles. That extended warranty has since expired, and Subaru has declined goodwill coverage despite the defect being documented by an authorized Subaru dealership (SOA Case No. 260106-1800881). The screen serves as the primary interface for the backup camera, navigation, and climate controls. Obscured visibility of this screen while driving creates a distraction hazard. I am requesting NHTSA investigate this defect and take appropriate action.
Read More...NHTSA ID Number: 11718878
Complaint Date: 2026-02-18
Fail Date: 2026-01-29
Manufacturer Name: Ford Motor Company
Vehicle Make: FORD
Vehicle Model: FUSION
Model Year: 2017
Summary
The contact owns a 2017 Ford Fusion. The contact stated that while her granddaughter was driving at an undisclosed speed, the steering wheel detached and was left hanging. The driver moved over to the side of the highway. The contact stated that the steering wheel was previously repaired under NHTSA Campaign Number: 18V167000 (STEERING); however, the failure occurred. The vehicle was towed to a local dealer but was not repaired. The manufacturer was not notified of the failure. The failure mileage was 90,000.
Read More...NHTSA ID Number: 11718877
Complaint Date: 2026-02-18
Fail Date: 2026-02-12
Manufacturer Name: General Motors, LLC
Vehicle Make: GMC
Vehicle Model: SIERRA 1500
Model Year: 2014
Summary
The vehicle experienced complete lifter failure on cylinder number 4 bending the intake valve push rod thus shutting down the cylinder. The vehicle has 167,000 miles and is well maintained. The vehicle gave no warning signs that there was a problem. Simply driving down the road, normal engine temperature, normal oil pressure, the check engine light comes on at the same time the engine begins to mis-fire. Pulling over to the side of the road, I could hear lifter noise from the right bank of the engine. The dealership (Ocean Crest Chevrolet/GMC Warrenton, Oregon) confirmed the damage. The mechanic and the service manager both state the damage is a direct result of the GM cylinder deactivation system, and every single one they have repaired has been cylinder number 4. They further stated that GM has recommended a lifter change when repairing the damage, in other words, the lifters that were installed when the engine was originally built are defective. This damage occurs on both the 5.3 and the 6.2 with cylinder deactivation, and according to the dealership, it begins with cylinder number 4. This problem has also been responsible for cam damage which results in total engine replacement/rebuild due to metal contaminating the oil.
Read More...
- CEL Doctor: The ANCEL AD310 is one of the best-selling OBD II scanners on the market and is recommended by Scotty Kilmer, a YouTuber and auto mechanic. It can easily determine the cause of the check engine light coming on. After repairing the vehicle's problems, it can quickly read and clear diagnostic trouble codes of emission system, read live data & hard memory data, view freeze frame, I/M monitor readiness and collect vehicle information.
- Sturdy and Compact: Equipped with a 2.5 foot cable made of very thick, flexible insulation. It is important to have a sturdy scanner as it can easily fall to the ground when working in a car. The AD310 OBD2 scanner is a well-constructed mechanic tool with a sleek design. It weighs 12 ounces and measures 8.9 x 6.9 x 1.4 inches. Thanks to its compact design and light weight, transporting the device is not a problem. The buttons are clearly labelled and the screen is large and displays results clearly.
- Accurate Fast and Easy to Use: The AD310 scanner can help you or your mechanic understand if your car is in good condition, provides exceptionally accurate and fast results, reads and clears engine trouble emission codes in seconds after you fixed the problem. This device will let you know immediately and fix the problem right away without any car knowledge. No need for batteries or a charger, get power directly from the OBDII Data Link Connector in your vehicle.
- OBDII Protocols and Car Compatibility: Many cheap scan tools do not really support all OBD2 protocols. AD310 scanner as it can support all OBDII protocols such as KWP2000, J1850 VPW, ISO9141, J1850 PWM and CAN. This device also has extensive vehicle compatibility with 1996 US-based, 2000 EU-based and Asian cars, light trucks, SUVs, as well as newer OBD2 and CAN vehicles both domestic and foreign. Pls confirm with our customer service whether it is compatible with your vehicle before purchasing.
- Home Necessity and Worthy to Own: This is an excellent code reader to travel or home with as it weighs less and it is compact in design. You can easily slide it in your backpack as you head to the garage, or put it on the dashboard, this will be a great fit for you. The AD310 is not only portable, but also accurate and fast in performance. Moreover, it covers various car brands and is suitable for people who just need a code reader to check their car.
- Multi-Functions - Practical Multi-Functions OBD2 code reader features built-in OBD2 DTC lookup library, which help you to determine the cause of the engine light, read code, erase code, view freeze frame, I/M ready, vehicle information, data flow, real-time curve, get vehicle speed information, calculate load value, engine coolant temperature, get engine speed.
- Wide Capability - Supports 9 protocols compatible with most 1996 US-Based, 2000 EU-Based and Asian cars, and newer OBD II & CAN domestic or import vehicles. Supports 6 languages - English,German, Dutch, Spanish, French, Italian.
- 2.8" LCD Display - Designed with a clear display 2.8" Large LCD screen - white backlight and contrast adjustment. No need any battery or charger, OBD reader gets the power directly from your vehicle through the OBDII Data Link Connector.
- Compact Design - Car diagnostic scanner is equipped with a 2.5 feet long cable and made of a very thick flexible insulator.There are 6 buttons on OBD2 Scanner:scroll up/down,enter/exit and buttons that quick query VIN vehicle number& the DTC fault code.
- ABS / Airbag codes NOT Supported - It is able to read and clear check engine information which is part of OBDII system, but it cannot work with non-OBDII systems, including ABS / Airbag / Oil Service Light, etc.
- 【Your Personal CEL Doctor – Read & Clear Engine Codes】The NT301 OBD2 scanner lets you read diagnostic trouble codes (DTCs), check em-issions readiness, turn off your Check Engine Light (CEL) or MIL, reset monitors, and view live data streams. It retrieves your vehicle's VIN instantly. Like all standard OBD2 scanners, it clears codes only after repairs are completed—if the issue persists, the code will return. Designed for DIYers who want to understand what’s really going on under the hood.
- 【Easy Code Reading – Just Plug & Play】Simply plug into the OBD2 port, turn the ignition to “ON” (engine off), and select the correct menu: Select OBDII-> Wait for seconds-> Select Read codes. For accurate results, ensure your vehicle is compatible and the OBD2 port is free from damage or wiring issues. No batteries needed— powered directly by your car.
- 【Live Data Graphing & Accuracy for Most OBD2 Vehicles】View and log live sensor data in graph form—monitor oxygen sensors, fuel trims, coolant temp, RPM, and more. Spot trends and suspicious values in real time. Compatible with most 1996+ gasoline cars, light trucks, and SUVs sold in the U.S., as well as many 2000+ European and Asian models. Also works on 12V diesel vehicles equipped with OBD2.
- 【S-mog Check Helper – Know Your Readiness Status at a Glance】With dedicated I/M readiness hotkeys and a simple Red-Yellow-Green LED indicator, you’ll instantly know if your vehicle is ready for em-issions testing. Built-in speaker provides audio feedback. No guesswork—just confidence before you head to the test center.
- 【A Must-Have Tool for Every Home Mechanic】Compact, rugged, and ready to use right out of the box. The 2.8” color screen is easy to read, even in daylight. No charging or setup required—just plug into the 16-pin DLC and start diagnosing. Recommended by professional mechanics on YouTube and trusted by DIYers worldwide.
Last update on 2026-03-28 / Affiliate links / Images from Amazon Product Advertising API
This product presentation was made with AAWP plugin.